No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S V800R010C10SPC500 Configuration Guide - MPLS 01

This is NE20E-S V800R010C10SPC500 Configuration Guide - MPLS
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring MPLS Resource Threshold-related Alarms

Configuring MPLS Resource Threshold-related Alarms

MPLS resource threshold-related alarms can be configured on a device to enable the device to report an alarm if the number of MPLS resources of a specified type reaches the upper limit. The alarms facilitate operation and maintenance.

Usage Scenario

If the proportion of used MPLS resources, such as LSPs and dynamic labels to all supported ones reaches a specified upper limit, new MPLS services may fail to be established because of insufficient resources. To facilitate operation and maintenance, an upper alarm threshold of MPLS resource usage can be set. If MPLS resource usage reaches the specified upper alarm threshold, an alarm is generated.

Pre-configuration Tasks

Before configuring MPLS resource threshold-related alarms, configure basic MPLS functions.

Configuration Procedures

The configuration steps can be performed in any order.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055103

Views: 22083

Downloads: 37

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next