No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S V800R010C10SPC500 Configuration Guide - MPLS 01

This is NE20E-S V800R010C10SPC500 Configuration Guide - MPLS
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Static BFD for CR-LSP

Configuring Static BFD for CR-LSP

By configuring static BFD for CR-LSP, you can monitor a static CR-LSP or an RSVP CR-LSP.

Usage Scenario

BFD for CR-LSP monitors the primary and hot-standby CR-LSPs and triggers traffic switchovers between them.

NOTE:

When static BFD for CR-LSP is used and the BFD status is Up, the BFD status remains Up even after the tunnel interface of the CR-LSP is shut down.

Pre-configuration Tasks

Before configuring static BFD for CR-LSP, configure an RSVP-TE tunnel or CR-LSP backup.

Configuration Procedures

Figure 3-17 Static BFD for CR-LSP configuration

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055103

Views: 21957

Downloads: 37

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next