No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S V800R010C10SPC500 Configuration Guide - MPLS 01

This is NE20E-S V800R010C10SPC500 Configuration Guide - MPLS
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the MPLS TE Tunnel Interface

Configuring the MPLS TE Tunnel Interface

This section describes how to configure the MPLS TE tunnel interface. You must create a tunnel interface before setting up an MPLS TE tunnel.

Context

Perform the following steps on the ingress of a static CR-LSP:

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface tunnel interface-number

    The tunnel interface is created, and the tunnel interface view is displayed.

  3. To configure the IP address of the tunnel interface, select one of the following commands.

    • To specify the IP address of the tunnel interface, run ip address ip-address { mask | mask-length } [ sub ]

      The secondary IP address of the tunnel interface can be configured only after the primary IP address is configured.

    • To borrow an IP address from another interface, run ip address unnumbered interface interface-type interface-number

    An MPLS TE tunnel can be established even if the tunnel interface is assigned no IP address. The tunnel interface must obtain an IP address before forwarding traffic. An MPLS TE tunnel is unidirectional; therefore, its peer address is irrelevant to traffic forwarding. A tunnel interface does not need to be assigned an IP address but uses the ingress LSR ID as its IP address.

  4. Run tunnel-protocol mpls te

    MPLS TE is configured to be the tunnel protocol.

  5. Run destination ip-address

    The destination address of the tunnel is configured, which is usually the LSR ID of the egress node.

  6. Run mpls te tunnel-id tunnel-id

    The tunnel ID is configured.

  7. Run mpls te signal-protocol cr-static

    The signal protocol of the tunnel is configured to be static CR-LSP.

  8. Run commit

    The configurations are committed.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055103

Views: 22097

Downloads: 37

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next