No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S V800R010C10SPC500 Configuration Guide - MPLS 01

This is NE20E-S V800R010C10SPC500 Configuration Guide - MPLS
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Locking the Tunnel Configuration

Locking the Tunnel Configuration

Tunnel configurations can be locked by the controller when the configurations are sent to a NE20E.

Usage Scenario

In service delivery, a controller delivers tunnel configurations to a NE20E. The NE20E uses the obtained configurations to create a tunnel or modify an existing tunnel. To prevent users from modifying such tunnel configurations, the controller delivers the mpls te lock command to lock the configurations, in addition to configurations to the NE20E. Before you modify the configuration of a tunnel, run the undo mpls te lock command to unlock the tunnel configuration on the tunnel interface.

Pre-configuration Tasks

Before locking the tunnel configuration, complete the following tasks:

  • Configure the controller to deliver tunnel configurations to a NE20E.

  • Assign a user management rights.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface tunnel interface-number

    The tunnel interface view of an MPLS TE tunnel is displayed.

  3. Run mpls te lock

    The configuration of the MPLS TE tunnel is locked.

  4. Run commit

    The configuration is committed.

Checking the Configurations

After locking the tunnel configurations, verify that no command can be run on the tunnel interface to modify configurations and commands can be run only after the undo mpls te lock command is run to unlock the configurations.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055103

Views: 19921

Downloads: 35

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next