No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S V800R010C10SPC500 Configuration Guide - MPLS 01

This is NE20E-S V800R010C10SPC500 Configuration Guide - MPLS
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Establishing an MP-EBGP Peer Relationship Between Each AGG and MASG

Establishing an MP-EBGP Peer Relationship Between Each AGG and MASG

MP-EBGP supports BGP extended community attributes that are used to advertise VPNv4 routes between each pair of the AGG and MASG.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run bgp { as-number-plain | as-number-dot }

    The BGP view is displayed.

  3. Run peer ipv4-address as-number { as-number-plain | as-number-dot }

    A BGP peer is configured.

  4. Run peer { ipv4-address | group-name } connect-interface loopback interface-number

    The interface on which a TCP connection to the specified BGP peer is established is specified.

    NOTE:

    The AGG and MASG must use loopback interface addresses with 32-bit masks to establish an MP-EBGP peer relationship so that the MP-EBGP connection can be iterated to a tunnel.

  5. Run peer ipv4-address ebgp-max-hop [ hop-count ]

    The maximum number of hops for an EBGP peer relationship is set.

  6. Run ipv4-family vpnv4

    The BGP-VPNv4 address family view is displayed.

  7. Run peer { ipv4-address | group-name } enable

    The ability to exchange BGP-VPNv4 routes with the specified BGP peer is enabled.

  8. (Optional) Run ipv4-family unicast

    The BGP-IPv4 unicast address family view is displayed.

  9. (Optional) Run undo peer { ipv4-address | group-name } enable

    The ability to exchange BGP-VPNv4 unicast routes between BGP peers is disabled.

    If multiple links between two ASs exist, the ability to exchange BGP-VPNv4 unicast routes between BGP peers must be disabled to prevent route loops between BGP peers that establish MP-EBGP peer relationships.

  10. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055103

Views: 19913

Downloads: 35

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next