No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S V800R010C10SPC500 Configuration Guide - MPLS 01

This is NE20E-S V800R010C10SPC500 Configuration Guide - MPLS
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring an LDP Label Advertisement Mode

(Optional) Configuring an LDP Label Advertisement Mode

An LDP label advertisement mode can be configured to control LSP establishment.

Context

A downstream LSR sends a Label Mapping message to an upstream LSR in downstream unsolicited mode (DU) by default. This allows multiple LSPs including backup LSPs to be established. If a network fault occurs, services rapidly switch to a backup LSP, improving network reliability. Establishing a large number of LSPs burdens an LSR such as a digital subscriber link access multiplexer (DSLAM) that is a low-performance access device deployed on an MPLS network. On a large-scale network, a DSLAM can be configured to send Label Mapping messages to only upstream LSRs only after receiving requests for labels. This minimizes the number of unwanted MPLS forwarding entries forwarded by the DSLAM.

Procedure

  • Configuring an LDP Label Advertisement Mode of local LDP session.
    1. Run system-view

      The system view is displayed.

    2. Run interface interface-type interface-number

      The interface view is displayed.

    3. Run mpls ldp advertisement { dod | du }

      A label advertisement mode is configured.

      NOTE:
      • A pair of LDP peers must have the same label advertisement mode. Inconsistency in label advertisement modes causes the two LDP peers to fail to establish LDP LSPs between them over multiple links.

      • Modifying a configured label advertisement mode leads to the reestablishment of an LDP session, resulting in service interruptions.

    4. Run commit

      The configuration is committed.

  • Configuring an LDP Label Advertisement Mode of remote LDP session.
    1. Run system-view

      The system view is displayed.

    2. Run mpls ldp remote-peer remote-peer-name

      The remote MPLS LDP peer is created and the remote MPLS LDP peer view is displayed.

    3. Run mpls ldp advertisement { dod | du }

      A label advertisement mode is configured.

      NOTE:

      When the local and remote LDP sessions coexist, they must have the same label advertisement mode.

    4. Run commit

      The configuration is committed.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055103

Views: 19579

Downloads: 35

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next