No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


NE20E-S V800R010C10SPC500 Configuration Guide - MPLS 01

This is NE20E-S V800R010C10SPC500 Configuration Guide - MPLS
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring PHP

Configuring PHP

When you configure penultimate hop popping (PHP), specify a label that the egress assigns to the penultimate hop.


Perform the following steps on the egress:


  1. Run system-view

    The system view is displayed.

  2. Run mpls

    The MPLS view is displayed.

  3. Run label advertise { explicit-null | implicit-null | non-null }

    The label assigned to the penultimate node is specified.

    You can specify one of the following parameters:

    • explicit-null: disables PHP. If this parameter is configured, the egress assigns an explicit null label with value 0 to the penultimate node. explicit-null supports MPLS QoS, which helps save label resources in the egress. If E2E services with QoS attributes carried in the EXP field in a label, explicit-null can be configured to save label resources and prevent EXP value loss.

    • non-null: disables PHP. If this parameter is configured, the egress assigns a label with a value greater than or equal to 16 to the penultimate node. The non-null label consumes resources on the egress, which is not recommended. This parameter can be used when the egress needs to identify services based on labels.


    PHP takes effect on LSPs that are to be established, but not on existing LSPs.

  4. Run commit

    The configuration is committed.

Updated: 2019-01-03

Document ID: EDOC1100055103

Views: 20121

Downloads: 35

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next