No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S V800R010C10SPC500 Configuration Guide - MPLS 01

This is NE20E-S V800R010C10SPC500 Configuration Guide - MPLS
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling BFD for RSVP

Enabling BFD for RSVP

You can enable BFD for RSVP either globally or on a specified interface.

Context

Perform either of the following operations:

Procedure

  • Enable BFD for RSVP globally.

    Perform the following steps on the two RSVP neighboring nodes between which a Layer 2 device resides:

    1. Run system-view

      The system view is displayed.

    2. Run mpls

      The MPLS view is displayed.

    3. Run mpls rsvp-te bfd all-interfaces enable

      BFD for RSVP is enabled globally.

      After this command is run in the MPLS view, BFD for RSVP is enabled on all RSVP interfaces except the interfaces with BFD for RSVP that are blocked.

    4. (Optional) Block BFD for RSVP on the RSVP interfaces that do not need BFD for RSVP.

      1. Run interface interface-type interface-number

        The view of the RSVP-TE-enabled interface is displayed.

      2. Run mpls rsvp-te bfd block

        BFD for RSVP is blocked on the interface.

    5. Run commit

      The configuration is committed.

  • Enable BFD for RSVP on the RSVP interface.

    Perform the following steps on the two RSVP neighboring nodes between which a Layer 2 device resides:

    1. Run system-view

      The system view is displayed.

    2. Run interface interface-type interface-number

      The view of the RSVP-TE-enabled interface is displayed.

    3. Run mpls rsvp-te bfd enable

      BFD for RSVP is enabled on the RSVP interface.

    4. Run commit

      The configuration is committed.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055103

Views: 19564

Downloads: 35

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next