No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S V800R010C10SPC500 Configuration Guide - MPLS 01

This is NE20E-S V800R010C10SPC500 Configuration Guide - MPLS
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Disabling LDP LSP Flapping Suppression

(Optional) Disabling LDP LSP Flapping Suppression

LDP LSP flapping suppression helps effectively prevent label flapping. This function can be disabled.

Context

After an LDP LSP goes Up, it goes Down due to a protocol or interface failure. A device attempts to reestablish the LDP LSP, which maximizes the LDP LSP protocol hard convergence. If LDP LSP alternates between Up and Down when a downstream node frequently sends a label to an upstream node or a label is withdrawn, CPU usage increases. To prevent label suppression, configure LDP LSP flapping suppression.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run mpls

    The MPLS view is displayed.

  3. Run mpls ldp

    MPLS LDP has been enabled globally.

  4. Run protocol-packets suppress disable

    LDP LSP flapping suppression is disabled.

  5. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055103

Views: 19576

Downloads: 35

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next