No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S V800R010C10SPC500 Configuration Guide - MPLS 01

This is NE20E-S V800R010C10SPC500 Configuration Guide - MPLS
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Specifying an MPLS TTL Handling Mode

Specifying an MPLS TTL Handling Mode

An MPLS time to live (TTL) handling mode defines how a node propagates TTL information between the IP header and label stack in each MPLS packet.

Usage Scenario

MPLS nodes handle TTLs as follows:

  • Nodes process TTLs in either uniform or pipe mode before the TTLs expire.You can configure an MPLS TTL processing mode on the ingress PE.

    Configure the pipe mode on the ingress for an MPLS virtual private networks (VPN) so that the MPLS backbone network structure can be hidden, which improves network security.

  • Nodes process expired MPLS TTLs and reply with ICMP reply messages.

    On an ISP backbone network that transmits VPN traffic over MPLS tunnels, after an MPLS node receives an MPLS packet with two labels and an expired TTL, the MPLS node replies to the source with an ICMP reply message. Because the MPLS node cannot send the ICMP reply message over IP routes, the ICMP reply message travels along an LSP to the egress. The egress forwards the ICMP reply message to the source over IP routes.

    On an ISP backbone that transmits VPN traffic over MPLS tunnels, after an MPLS node receives MPLS packets each with a single label and an expired TTL, the MPLS node replies to the source with an ICMP reply message over IP routes, without forwarding the message to the egress along the LSP. If the MPLS node has no reachable route to the transmit end, the ICMP reply message is discarded. As a result, traceroute results do not contain node information.

    On an autonomous system boundary router (ASBR) in the inter-AS VPN Option B and a superstratum provider edge (SPE) of the hierarchy of virtual private networks (HoVPNs), each MPLS packet that contains VPN information carries a single label. If the TTL in the MPLS packet expires, a node replies with an ICMP reply message over an IP route, and the ICMP reply message does not carry MPLS node information. Therefore, before you perform the traceroute operation on the ASBR or SPE, run the undo ttl expiration pop command on the ASBR or SPE to enable ICMP reply messages to travel along LSPs.

NOTE:

For information about HoVPN and SPEs, see HUAWEI NE20E-S Universal Service Router Configuration Guide - VPN.

Pre-configuration Task

Before configuring an MPLS TTL processing mode, configure MPLS or the MPLS IP VPN.

Configuration Procedures

The configuration steps can be performed in any order.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055103

Views: 21962

Downloads: 37

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next