No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S V800R010C10SPC500 Configuration Guide - MPLS 01

This is NE20E-S V800R010C10SPC500 Configuration Guide - MPLS
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Checking Tunnel Error Information

Checking Tunnel Error Information

If an RSVP-TE tunnel interface is Down, run display commands to view information about faults.

Context

Run the display mpls te tunnel-interface last-error command on the ingress to view the last five recorded errors that occurred on a TE tunnel. The following errors may occur:
  • CSPF computation failures
  • Errors that occurred when RSVP signaling was triggered
  • Errors carried in received RSVP PathErr messages

Procedure

  1. Run the display mpls te tunnel-interface last-error [ tunnel-name ] command to check error information on a tunnel interface.
Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055103

Views: 20094

Downloads: 35

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next