No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


NE20E-S V800R010C10SPC500 Configuration Guide - MPLS 01

This is NE20E-S V800R010C10SPC500 Configuration Guide - MPLS
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Packet Load Balancing Mode

Configuring a Packet Load Balancing Mode

You can configure a load balancing mode for packets carrying MPLS labels on a P.


The router supports either of the following packet load balancing modes:
  • Per-packet load balancing: evenly balances packets, regardless of packet sequences.
  • Per-destination load balancing: balances packets and forwards them in correct sequence.


  1. Run system-view

    The system view is displayed.

  2. Run load-balance { flow | packet } [ slot slot-id | all ]

    A load balancing mode is specified.

  3. Run commit

    The configuration is committed.

Updated: 2019-01-03

Document ID: EDOC1100055103

Views: 19480

Downloads: 35

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next