No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S V800R010C10SPC500 Configuration Guide - MPLS 01

This is NE20E-S V800R010C10SPC500 Configuration Guide - MPLS
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring a PCE Client to Delegate TE LSPs to All PCE Servers

(Optional) Configuring a PCE Client to Delegate TE LSPs to All PCE Servers

A PCE client can be configured to delegate TE LPSs to all PCE servers. This configuration prevents a PCE server path calculation failure if forwarders select a master PCE server different from that configured on a controller.

Usage Scenario

In a PCE+ scenario, forwarders (PCE clients) select the master and backup PCE servers. Each PCE client delegates all TE LSPs to the selected or highest-priority PCE server. The PCE server can then calculate paths for the delegated TE LSPs. In geographical redundancy, the master and backup PCE servers are configured on controllers. In this situation, the forwarders may select a master PCE server different from that configured on a controller, causing a master PCE server inconsistency. After PCE clients delegate all TE LSPs to the selected PCE server, the master PCE server configured on the controller cannot calculate paths. To prevent a path calculation failure, run the multi-delegate enable command to enable a PCE client to delegate TE LSPs to all PCE servers that have established PCEP sessions to the PCE client.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run pce-client

    The PCE client view.

  3. Run multi-delegate enable

    The PCE client is enabled to delegate TE LSPs to all PCE servers along established PCEP sessions.

  4. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055103

Views: 19887

Downloads: 35

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next