No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S V800R010C10SPC500 Configuration Guide - MPLS 01

This is NE20E-S V800R010C10SPC500 Configuration Guide - MPLS
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Using the Automatic Primary Tunnel Function to Establish P2P TE Tunnels in a Batch

Using the Automatic Primary Tunnel Function to Establish P2P TE Tunnels in a Batch

The automatic primary tunnel function can be used to establish P2P TE tunnels in a batch.

Context

The automatic primary tunnel function uses a specified IP prefix list in which destination IP addresses are defined so that tunnels to the destination IP addresses can be established in a batch. The automatic primary tunnel function can also use a specified tunnel template that defines public attributes before creating tunnels in a batch.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run mpls te auto-primary-tunnel ip-prefix ip-prefix [ p2p-template template-name ]

    The automatic primary tunnel function is configured.

  3. (Optional) Set the hold time for tunnels.
    1. Run mpls

      The MPLS view is displayed.

    2. Run mpls te timer auto-primary-tunnel delay-delete time-value

      The hold time for tunnels is set.

  4. Run commit

    The configuration is committed.

Follow-up Procedure

If errors occur in services transmitted on a TE tunnel and the services cannot be restored, run the reset mpls te auto-primary-tunnel command in the user view to reestablish the TE tunnel to restore the services.

After this command is run, all LSPs in the specified tunnel are torn down and reestablished. If some LSPs are transmitting traffic, the operation causes a traffic interruption. Exercise caution when using this command.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055103

Views: 19891

Downloads: 35

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next