No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S V800R010C10SPC500 Configuration Guide - MPLS 01

This is NE20E-S V800R010C10SPC500 Configuration Guide - MPLS
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the LDP Remote Peer

Configuring the LDP Remote Peer

Before you configure a remote LDP session, specify the name and IP address of the remote peer.

Context

A remote LDP session can be established between nonadjacent LSRs or between adjacent LSRs.

A local LDP session and a remote LDP session can be configured together between the same two LSRs.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run mpls ldp remote-peer remote-peer-name

    A remote MPLS LDP peer is created, and the remote MPLS LDP peer view is displayed.

  3. (Optional) Run description description-value

    The description of a remote peer is configured.

  4. Run remote-ip ip-address

    The IP address is assigned to the remote MPLS LDP peer.

    The remote MPLS LDP peer must use the LSR ID as the IP address.

    NOTE:
    • The IP address of a remote LDP peer must be the LSR ID of the remote LDP peer. If an LDP LSR ID is different from an MPLS LSR ID, the LDP LSR ID is used.

    • Modifying or deleting a configured IP address of a remote peer also deletes the remote LDP session.

  5. (Optional) Select either of the following modes to prevent labels from being distributed to a remote MPLS LDP peer:

    • Run remote-ip ip-address pwe3

      The local LSR is prevented from distributing labels to a specified remote MPLS LDP peer.

    • Run the following commands to prevent labels from being distributed to all remote MPLS LDP peers.
      • Run quit

        Return to the system view.

      • Run mpls ldp

        The MPLS-LDP view is displayed.

      • Run remote-peer pwe3

      The local LSR is disabled from distributing labels to all remote MPLS LDP peers.

    NOTE:

    When, run the preceding commands to prohibit labels from being distributed to the remote MPLS LDP peers, which helps efficiently use system resources. When TE services are transmitted over a backbone network in the LDP over TE scenario, do not perform this configuration.

  6. Run commit

    The configurations are committed.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055103

Views: 19870

Downloads: 35

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next