No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S V800R010C10SPC500 Configuration Guide - MPLS 01

This is NE20E-S V800R010C10SPC500 Configuration Guide - MPLS
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Tunnel Interface on the Egress

Configuring the Tunnel Interface on the Egress

The reverse tunnel attribute is configured, and the tunnel interface is bound to a static bidirectional co-routed LSP on the egress.

Context

Perform the following steps on the egress of a static bidirectional co-routed LSP:

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface tunnel interface-number

    A tunnel interface is created, and the tunnel interface view is displayed.

  3. Run tunnel-protocol mpls te

    MPLS TE is configured as a tunnel protocol to create an MPLS TE tunnel.

  4. Run destination ip-address

    The destination address is configured for the tunnel. It is usually the LSR ID of the ingress.

    Various types of tunnels have different requirements for destination addresses. If a tunnel protocol is changed to MPLS TE, the destination address configured using the destination command is automatically deleted and needs to be reconfigured.

  5. Run mpls te tunnel-id tunnel-id

    The tunnel ID is configured.

  6. Run mpls te signal-protocol cr-static

    A static CR-LSP is configured.

  7. Run mpls te passive-tunnel

    The reverse tunnel attribute is configured.

  8. Run mpls te binding bidirectional static-cr-lsp egress tunnel-name

    The tunnel interface is bound to the specified static bidirectional co-routed LSP.

  9. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055103

Views: 20164

Downloads: 35

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next