No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S V800R010C10SPC500 Configuration Guide - MPLS 01

This is NE20E-S V800R010C10SPC500 Configuration Guide - MPLS
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the P2MP TE Auto FRR Configuration

Verifying the P2MP TE Auto FRR Configuration

After configuring P2MP TE Auto FRR, verify P2MP TE Auto FRR information.

Prerequisites

P2MP TE Auto FRR has been configured.

Procedure

  • Run the display mpls te p2mp tunnel frr [ tunnel-name ] [ lsp-id ingress-lsr-id session-id local-lsp-id [ s2l-destination leaf-address ] ] command to check bypass tunnel attributes.

Example

After completing the configurations, run the display mpls te p2mp tunnel frr command on the point of local repair (PLR) to view the bypass tunnel status and bypass tunnel attributes.

<HUAWEI> display mpls te p2mp tunnel frr
 Tunnel Interface Name : Tunnel10
 Lsp ID : 1.1.1.1 :1 :9
 S2L Dest Addr: 3.3.3.3
 Sub-Group Originator ID:1.1.1.1    Sub-Group ID:257
 Bypass In Use           :  Not Exists
 Bypass Tunnel ID        :  0
 BypassTunnel            :  -
 Bypass LSP ID           :  -           
 FrrNextHop              :  -
 Bypass Attribute(Not configured)
 Setup Priority          :  -            
 Hold Priority           :  -           
 HopLimit                :  -           
 Bandwidth               :  -           
 IncludeAnyGroup         :  -          
 ExcludeAnyGroup         :  -           
 IncludeAllGroup         :  -           
  
 Tunnel Interface Name : Tunnel10
 Lsp ID : 1.1.1.1 :1 :10
 S2L Dest Addr: 3.3.3.3
 Sub-Group Originator ID:1.1.1.1    Sub-Group ID:258
 Bypass In Use           :  Not Used
 Bypass Tunnel ID        :  32769
 BypassTunnel            :  Tunnel Index[AutoTunnel32769], InnerLabel[32769]
 Bypass LSP ID           :  11          
 FrrNextHop              :  3.1.1.1
 Bypass Attribute
 Setup Priority          :  7           
 Hold Priority           :  7
 HopLimit                :  32          
 Bandwidth               :  0
 IncludeAnyGroup         :  0           
 ExcludeAnyGroup         :  0
 IncludeAllGroup         :  0
Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055103

Views: 20162

Downloads: 35

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next