No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


NE20E-S V800R010C10SPC500 Configuration Guide - MPLS 01

This is NE20E-S V800R010C10SPC500 Configuration Guide - MPLS
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Dynamic BFD for LDP LSPs

Configuring Dynamic BFD for LDP LSPs

Dynamic bidirectional forwarding detection (BFD) for LDP LSPs is used to rapidly check LDP LSP connectivity to improve network reliability.

Usage Scenario

Dynamic BFD for LDP LSPs detects link faults rapidly and reduces configuration workloads. It can be used together with LDP FRR to reduce the impact of link faults on services.

Note that dynamic BFD can be used to check LDP LSPs established only using host routes.

Pre-configuration Tasks

Before configuring dynamic BFD for LDP LSPs, complete the following tasks:

Configuration Procedures

Figure 4-6 BFD for LDP LSP configuration

Updated: 2019-01-03

Document ID: EDOC1100055103

Views: 20105

Downloads: 35

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next