No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


NE20E-S V800R010C10SPC500 Configuration Guide - MPLS 01

This is NE20E-S V800R010C10SPC500 Configuration Guide - MPLS
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling TE FRR

Enabling TE FRR

TE FRR must be enabled on the ingress of a primary tunnel before TE manual FRR is configured.


  1. Run system-view

    The system view is displayed.

  2. Run interface tunneltunnel-number

    The view of the primary MPLS TE tunnel interface is displayed.

  3. Run mpls te fast-reroute [ bandwidth ]

    TE FRR is enabled.


    After TE FRR is enabled using the mpls te fast-reroute command, run the mpls te bypass-attributes command to set bypass tunnel attributes.

  4. Run commit

    The configuration is committed.

Updated: 2019-01-03

Document ID: EDOC1100055103

Views: 21785

Downloads: 37

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next