No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S V800R010C10SPC500 Configuration Guide - MPLS 01

This is NE20E-S V800R010C10SPC500 Configuration Guide - MPLS
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling MPLS TE and RSVP-TE

Enabling MPLS TE and RSVP-TE

Enabling MPLS TE and RSVP-TE on each node and interface in an MPLS domain is the prerequisites for all TE features.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run mpls lsr-id lsr-id

    An LSR ID is set for a local node.

    Note the following issues when setting an LSR ID:
    • LSR IDs must be set before other MPLS commands are run.

    • No default LSR ID is available.

    • Using the IP address of a loopback interface as the LSR ID is recommended for an LSR.

  3. Run mpls

    The MPLS view is displayed.

  4. Run mpls te

    MPLS TE is enabled globally.

  5. Run mpls rsvp-te

    RSVP-TE is enabled.

  6. Run quit

    The system view is displayed.

  7. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055103

Views: 21797

Downloads: 37

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next