No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S V800R010C10SPC500 Configuration Guide - MPLS 01

This is NE20E-S V800R010C10SPC500 Configuration Guide - MPLS
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an Explicit Path

Configuring an Explicit Path

GMPLS UNI cannot automatically discover paths between an IP network and a transport network. To ensure successful GMPLS UNI establishment, configure an explicit path on the ingress EN to traverse data channel interfaces on the ingress EN, ingress CN, egress EN, and egress CN.

Context

Determine whether you need to configure an explicit path based on a tunnel calculation mode:
  • If paths are calculated separately at the IP and optical layers, configure an explicit path.

  • If PCE is used to calculate a patch across both the IP and optical layers, you do not need to configure an explicit path. This is because PCE automatically calculates a path for a tunnel.

A GMPLS UNI tunnel originates from the ingress EN. An explicit path must be configured on the ingress EN for a GMPLS UNI tunnel.

NOTE:

An explicit path for a GMPLS UNI tunnel, different from that for an MPLS TE tunnel, must pass through only four data channel interfaces on the ingress EN, ingress CN, egress EN, and egress CN.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run explicit-path path-name

    An explicit path is created and the explicit path view is displayed.

  3. Run next hop ip-address

    A next-hop address is specified for the explicit path.

    NOTE:

    Perform Step 3 for four consecutive times to complete the configuration of the explicit path for a GMPLS UNI tunnel.

  4. (Optional) Perform the following steps to modify the configured explicit path:
    1. Run add hop ip-address1 { after | before } ip-address2

      A node is added to the explicit path.

    2. Run modify hop ip-address1 ip-address2

      The address of a node is changed to the address of another existing node.

    3. Run delete hop ip-address

      A node is deleted from the explicit path.

  5. (Optional) Run list hop [ ip-address ]

    Information about nodes on the explicit path is displayed.

  6. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055103

Views: 19765

Downloads: 35

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next