No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


NE20E-S V800R010C10SPC500 Configuration Guide - MPLS 01

This is NE20E-S V800R010C10SPC500 Configuration Guide - MPLS
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the LDP Multi-Instance

Configuring the LDP Multi-Instance

You need to configure the LDP multi-instance when deploying the BGP/MPLS IP VPN.

Usage Scenario

The LDP multi-instance is used on the BGP/MPLS VPN. To configure the LDP multi-instance, bind LDP to a created IP VPN instance.

Pre-configuration Tasks

Before configuring an LDP multi-instance, complete the following tasks:

  • Enable MPLS.

  • Enable MPLS LDP.

  • Configure the IP VPN instance.

Configuration Procedures

Updated: 2019-01-03

Document ID: EDOC1100055103

Views: 19943

Downloads: 35

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next