No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S V800R010C10SPC500 Configuration Guide - MPLS 01

This is NE20E-S V800R010C10SPC500 Configuration Guide - MPLS
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring P2MP TE Auto FRR

Configuring P2MP TE Auto FRR

Auto fast reroute (FRR) is a local protection mechanism in MPLS TE. Auto FRR deployment is easier than manual FRR deployment.

Usage Scenario

FRR protection is configured for networks requiring high reliability. If P2MP TE manual FRR is used (configured by following the steps in Configuring P2MP TE FRR), a lot of configurations are needed on a network with complex topology and a great number of links to be protected. In this situation, P2MP TE Auto FRR can be configured.

Unlike P2MP TE manual FRR, P2MP TE Auto FRR automatically creates a bypass tunnel that meets traffic requirements, which simplifies configurations.

The NE20E supports upgrade binding that if a bypass tunnel with a priority higher than an existing bypass tunnel is calculated, the primary tunnel will be automatically unbound from the existing bypass tunnel and bound to the one with the higher priority. A bypass tunnel is selected based on the following rules prioritized in descending order:
  • An SRLG attribute is configured for a bypass tunnel.

  • If P2MP TE Auto FRR and an SRLG attribute are configured, the primary and bypass tunnels must be in different SRLGs. If these two tunnels are in the same SRLG, the bypass tunnel may fail to be established.

  • A bypass tunnel with bandwidth protection configured takes preference over that with non-bandwidth protection configured.

A bypass tunnel provides link protection, not node protection, for its primary tunnel.

Pre-configuration Tasks

Before configuring P2MP TE Auto FRR, complete the following tasks:

  • Configure a primary P2MP TE tunnel.

  • Enable MPLS, MPLS TE, and RSVP-TE globally and in the physical interface view on each node along a bypass tunnel to be established. For configuration details, see Enabling MPLS TE and RSVP-TE.

  • (Optional) To protect bandwidth of the primary tunnel, set the physical link bandwidth for the bypass tunnel to be established. For configuration details, see (Optional) Configuring Link TE Attributes.

  • Enable CSPF on each node along the bypass tunnel to be established.

Configuration Procedures

Figure 3-12 Flowchart for configuring P2MP TE Auto FRR
Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055103

Views: 22150

Downloads: 37

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next