No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


NE20E-S V800R010C10SPC500 Configuration Guide - MPLS 01

This is NE20E-S V800R010C10SPC500 Configuration Guide - MPLS
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring the MPLS MTU of an Interface

(Optional) Configuring the MPLS MTU of an Interface

An MPLS MTU can be configured on an interface to determine the maximum number of bytes in an MPLS packet that a device can forward without fragmenting the MPLS packet.


LDP selects the minimum value among MTUs on all outbound interfaces of an LSP. MPLS use the minimum MTU to determine the maximum size of each MPLS packet that can be forwarded without being fragmented. The MPLS MTU helps prevent forwarding failures on transit nodes.

The dependency between an MPLS MTU and an interface MTU is as follows:
  • If an interface MTU is set and no MPLS MTU is set on an interface, the interface MTU is used.

  • If both an MPLS MTU and an interface MTU are set on an interface, the smaller value between the MPLS MTU and the interface MTU is used.


The MPLS MTU of an interface can take effect only after the MTU signaling is enabled.


  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The view of the interface enabled with MPLS is displayed.

  3. Run mpls mtu mtu

    An MPLS MTU is set for an interface.

  4. (Optional) Run interface-mtu check-mode { ip | label-contained-length }slot slot-id

    An interface MTU check mode is configured.

    Choose a check mode based on scenarios:
    • ip: applies to IP forwarding scenarios.
    • label-contained-length: applies to MPLS forwarding scenarios.

    The device checks a packet's size based on the configured check mode and fragments a packet if its size exceeds the interface MTU.

    This command is supported only on the Admin-VS.

  5. Run commit

    The configurations are committed.

Updated: 2019-01-03

Document ID: EDOC1100055103

Views: 20179

Downloads: 35

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next