No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S V800R010C10SPC500 Configuration Guide - MPLS 01

This is NE20E-S V800R010C10SPC500 Configuration Guide - MPLS
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring LDP Auto FRR

Configuring LDP Auto FRR

LDP Auto Fast Reroute (FRR) can be configured to rapidly trigger a service switchover if a fault occurs, which improves network reliability.

Usage Scenario

On an MPLS network with a backup link, if a link fault occurs, Interior Gateway Protocol (IGP) routes converge and routes related to the backup link become available. After IGP route convergence is complete, an LDP LSP over the backup link becomes available. During this process, traffic is interrupted. To prevent traffic interruptions, LDP FRR can be configured.

LDP FRR uses the liberal label retention mode, obtains a liberal label, and applies for a forwarding entry associated with the label. It then forwards the forwarding entry to the forwarding plane as a backup forwarding entry used by the primary LSP. On the network enabled with LDP FRR, the interface can detect a fault that occurs on itself, and a BFD session associated with the interface can also detect a failure in the interface or the primary LSP established on the interface. If a fault occurs, LDP FRR is notified of the failure and rapidly forwards traffic to a backup LSP, protecting traffic on the primary LSP. The traffic switchover is performed within 50 milliseconds, which minimizes the traffic interruption time.

LDP Auto FRR depends on IGP FRR. When IGP FRR is enabled, LDP Auto FRR will be automatically enabled, and a backup LSP will be established based on a specific policy.

LFA Auto FRR cannot be used to calculate alternate links on large-scale networks, especially on ring networks. To address this problem, enable Remote LFA Auto FRR.

Pre-configuration Tasks

Before configuring LDP Auto FRR, complete the following tasks:

  • Assign an IP address to each interface to implement IP connectivity.

  • Configure an IGP to advertise the route to each network segment of each interface and to advertise the host route to each LSR ID.

  • Configuring an LDP LSP to establish a primary LDP LSP.

  • Configure IGP Auto FRR (Configuring IS-IS Auto FRR or Configuring OSPF IP FRR).

  • Before you configure Remote LFA FRR, configure LDP LSPs to be iterated hop by hop between the source node and PQ node. That is, configure a local LDP session between each pair of directly connected nodes along the link from the source node to PQ node.

Configuration Procedures

Figure 4-8 LDP Auto FRR configuration
Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055103

Views: 20004

Downloads: 35

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next