No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S V800R010C10SPC500 Configuration Guide - MPLS 01

This is NE20E-S V800R010C10SPC500 Configuration Guide - MPLS
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling the Packet Loss-Free MPLS ECMP Switchback

Enabling the Packet Loss-Free MPLS ECMP Switchback

The packet loss-free MPLS ECMP switchback can be enabled.

Context

In an L3VPN over BGP over TE or IP over BGP over TE scenario, after an MPLS TE tunnel is configured, the mpls load-balance wtr command is run in the system view to prevent packet loss during an MPLS ECMP switchback and set a switchback WTR time.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run mpls load-balance wtr wtr-value

    The packet loss-free MPLS ECMP switchback is enabled, and a switchback WTR time is set.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055103

Views: 19537

Downloads: 35

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next