No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


NE20E-S V800R010C10SPC500 Configuration Guide - MPLS 01

This is NE20E-S V800R010C10SPC500 Configuration Guide - MPLS
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring a Manual Switching Mechanism for a Primary/Hot-Standby CR-LSP

(Optional) Configuring a Manual Switching Mechanism for a Primary/Hot-Standby CR-LSP

This section describes how to configure a manual switching mechanism for a primary/hot-standby CR-LSP. This mechanism allows you to control primary/hot-standby CR-LSP switchovers using commands.


When a primary CR-LSP needs to be adjusted, you can switch the traffic to the hot-standby CR-LSP using the hotstandby-switch force command. After the primary CR-LSP has been adjusted, you can switch back the traffic to the primary CR-LSP using the hotstandby-switch clear command.


  1. Run system-view

    The system view is displayed.

  2. Run interface tunnel tunnel-number

    The view of the MPLS TE tunnel interface is displayed.

  3. Run hotstandby-switch { force | clear }

    A manual switching mechanism for the primary/hot-standby CR-LSP is configured.

    If you specify force, the traffic switches temporarily to the hot-standby CR-LSP. If you specify clear, the traffic switches back to the primary CR-LSP.

Updated: 2019-01-03

Document ID: EDOC1100055103

Views: 19899

Downloads: 35

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next