No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S V800R010C10SPC500 Configuration Guide - MPLS 01

This is NE20E-S V800R010C10SPC500 Configuration Guide - MPLS
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an LDP Entropy Label on the Ingress of an LSP

Configuring an LDP Entropy Label on the Ingress of an LSP

An LDP entropy label can be configured on the ingress of an LSP to load-balance traffic.

Context

The growth of user networks worsens the load imbalance on transit nodes. To address this problem, the entropy label capability can be configured on the ingress. An LDP entropy label is configured on the ingress of an LSP, and an LDP tunnel with the entropy label capability enabled is negotiated using LDP. Then forwarding entries carry the flag supporting the entropy label capability to implement load balancing.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run mpls ldp

    The MPLS-LDP view is displayed.

  3. Run entropy-label enable

    An LDP entropy label is configured on the ingress of an LSP.

  4. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055103

Views: 19860

Downloads: 35

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next