No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S V800R010C10SPC500 Configuration Guide - MPLS 01

This is NE20E-S V800R010C10SPC500 Configuration Guide - MPLS
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the RSVP Hello Extension

Configuring the RSVP Hello Extension

The RSVP Hello extension rapidly monitors the connectivity of RSVP neighbors.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run mpls

    The MPLS view is displayed.

  3. Run mpls rsvp-te hello

    The RSVP Hello extension is enabled on the local node.

  4. Run mpls rsvp-te hello-lost times

    The maximum number of Hello messages that can be discarded is set.

  5. Run mpls rsvp-te timer hello interval

    The interval at which Hello messages are refreshed is set.

    NOTE:

    If the refresh interval is changed, the modification takes effect after the existing refresh timer expires.

    The interval must be longer than the time a device takes to perform a master/slave main control board switchover. If the interval is set to less than the switchover time, a protocol intermittent interruption occurs during a switchover. The default timer value is recommended.

  6. Run quit

    The system view is displayed.

  7. Run interface interface-type interface-number

    The view of an RSVP-enabled interface is displayed.

  8. Run mpls rsvp-te hello

    The RSVP Hello extension is enabled on an interface.

    The RSVP Hello extension rapidly detects the reachability of RSVP neighbors. For details, see relevant standards.

  9. Run commit

    The configurations are committed.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055103

Views: 19758

Downloads: 35

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next