No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S V800R010C10SPC500 Configuration Guide - MPLS 01

This is NE20E-S V800R010C10SPC500 Configuration Guide - MPLS
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring Global Dynamic Bandwidth Pre-verification

(Optional) Configuring Global Dynamic Bandwidth Pre-verification

Global dynamic bandwidth pre-verification enables a device to check dynamic bandwidth usage before a static CR-LSP, or a static bidirectional co-routed LSP is established.

Context

When dynamic services or both static and dynamic services are configured, a device only checks static bandwidth usage when a static CR-LSP or a static bidirectional co-routed LSP is configured. The configuration is successful even if the interface bandwidth is insufficient, and the interface status is Down. To percent such an issue, global dynamic bandwidth pre-verification can be configured. With this function enable, the device can prompt a message indicating that the configuration fails in the preceding situation.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run mpls

    MPLS is enabled globally, and the MPLS view is displayed.

  3. Run mpls te

    MPLS TE is enabled globally.

    Global dynamic bandwidth pre-verification can only be configured after MPLS TE is enabled globally.

  4. Run mpls te static-cr-lsp bandwidth-check deduct-rsvp-bandwidth

    Global dynamic bandwidth pre-verification is enabled.

  5. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055103

Views: 19365

Downloads: 35

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next