No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S V800R010C10SPC500 Configuration Guide - MPLS 01

This is NE20E-S V800R010C10SPC500 Configuration Guide - MPLS
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting Priority Values for an MPLS TE Tunnel

Setting Priority Values for an MPLS TE Tunnel

The priority values are set on the ingress of an MPLS TE tunnel. Preemption is performed based on the setup and holding priorities during the establishment of an MPLS TE tunnel.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface tunnel tunnel-number

    The view of the MPLS TE tunnel interface is displayed.

  3. Run mpls te priority setup-priority [ hold-priority ]

    The priority values are set for the MPLS TE tunnel.

    Both the setup and holding priority values range from 0 to 7. The smaller the value, the higher the priority.

    NOTE:

    The setup priority value must be greater than or equal to the holding priority value. This means the setup priority is lower than or equal to the holding priority.

  4. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055103

Views: 19586

Downloads: 35

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next