No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S V800R010C10SPC500 Configuration Guide - MPLS 01

This is NE20E-S V800R010C10SPC500 Configuration Guide - MPLS
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Deleting an Automatic Bypass Tunnel and Re-establishing a New One

Deleting an Automatic Bypass Tunnel and Re-establishing a New One

If MPLS TE Auto FRR is enabled, a command is used to instruct a node to tear down an automatic bypass tunnel and reestablish a new one.

Procedure

  1. Run the reset mpls te auto-frr { lsp-id ingress-lsrid tunnel-id | name bypass-tunnel-name } command to tear down an automatic bypass tunnel and re-establish a new one.
Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055103

Views: 20122

Downloads: 35

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next