No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S V800R010C10SPC500 Configuration Guide - MPLS 01

This is NE20E-S V800R010C10SPC500 Configuration Guide - MPLS
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Limit Rate of MPLS TE Traffic

Configuring the Limit Rate of MPLS TE Traffic

This section describes how to configure the limit rate of MPLS TE traffic to limit TE tunnel traffic within the bandwidth range that is actually configured.

Usage Scenario

For a physical link of a TE tunnel, besides traffic on the TE tunnel, the physical link may bear MPLS traffic of other TE tunnels, MPLS traffic of other non-CR-LSPs, or even IP traffic simultaneously. To limit the TE tunnel traffic within a bandwidth range that is actually configured, set a limit rate for TE tunnel traffic.

After the configuration of the limit rate, TE traffic is limited to a bandwidth range that is actually configured. TE traffic with the bandwidth higher than the set bandwidth is dropped.

NOTE:
Before you configure the limit rate of MPLS TE traffic, run the mpls te bandwidth command on a tunnel interface. If this command is not run, the limit rate of MPLS TE traffic is unavailable.

Context

Before configuring the limit rate of MPLS TE traffic, configure a static CR-LSP or an RSVP-TE tunnel.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface tunnel tunnel-number

    The tunnel interface view is displayed.

  3. Run mpls te bandwidth

    The bandwidth constraint of the MPLS TE tunnel is configured.

  4. Run mpls te lsp-tp outbound

    The TE traffic policing is configured.

  5. Run commit

    The configuration is committed.

Checking the Configurations

  • Run the display current-configuration interface Tunnel tunnel-number command. The command output shows that the rate limit function has been enabled.

<HUAWEI> display current-configuration interface Tunnel 1
#
interface Tunnel1
 tunnel-protocol mpls te
 mpls te lsp-tp outbound
#
return
Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055103

Views: 19820

Downloads: 35

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next