No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S V800R010C10SPC500 Configuration Guide - MPLS 01

This is NE20E-S V800R010C10SPC500 Configuration Guide - MPLS
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Policy for Dynamically Establishing a BGP BFD Session

Configuring a Policy for Dynamically Establishing a BGP BFD Session

BGP BFD sessions can be dynamically established based on either host addresses or an IP address prefix list.

Context

The policies for dynamically establishing BGP BFD sessions are as follows:

  • Host address-based policy: used when all host addresses are available to trigger the creation of BGP BFD sessions.

  • IP address prefix list-based policy: used when only some host addresses can be used to establish BFD sessions.

Perform the following steps on the ingress of an E2E BGP tunnel:

Procedure

  1. Run system-view

    The system view is displayed.

  2. (Optional) Run ip ip-prefix ip-prefix-name [ index index-number ] { permit | deny } ipv4-address mask-length [ match-network ] [ greater-equal greater-equal-value ] [ less-equal less-equal-value ]

    An IPv4 address prefix list is configured, and list entries are configured.

    You can perform this step when you want to use an IP address prefix list to dynamically establish BGP BFD sessions. For configuration details about how to configure an IP address prefix list, see Configuring an IPv4 Address Prefix List.

  3. Run mpls

    The MPLS view is displayed.

  4. Run mpls bgp bfd-trigger-tunnel { host | ip-prefix ip-prefix-name }

    A policy for dynamically establishing a BGP BFD session is configured.

    After a policy is configured, the device starts to dynamically establish a BFD session.

  5. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055103

Views: 19761

Downloads: 35

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next