No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


NE20E-S V800R010C10SPC500 Configuration Guide - MPLS 01

This is NE20E-S V800R010C10SPC500 Configuration Guide - MPLS
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Optimizing MPLS

Optimizing MPLS

The optimizing MPLS include the label value related to the penultimate hop popping (PHP) function and the MPLS maximum transmission unit (MTU) configured on interfaces.

Usage Scenario

The following MPLS parameters can be adjusted:

  • Labels related to penultimate hop popping (PHP)

    The PHP function is configured on the egress. The egress assigns labels to the penultimate node based on the PHP status.

  • MPLS maximum transmission unit (MTU) on MPLS interfaces

    The MPLS MTU defines the maximum number of bytes in an MPLS packet that an interface can forward without fragmenting the packet. The default MPLS MTU on an interface is equal to the interface MTU.

Pre-configuration Task

Before adjusting MPLS parameters, configure MPLS.

Configuration Procedures

Updated: 2019-01-03

Document ID: EDOC1100055103

Views: 19803

Downloads: 35

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next