No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S V800R010C10SPC500 Configuration Guide - MPLS 01

This is NE20E-S V800R010C10SPC500 Configuration Guide - MPLS
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring a Policy for Triggering the Establishment of Transit LSPs

(Optional) Configuring a Policy for Triggering the Establishment of Transit LSPs

A policy for triggering the establishment of transit LSPs can be configured to enable LDP to use routes that meet the specified policy to establish transit LSPs.

Context

After MPLS LDP is enabled, LDP LSPs are automatically established. In this case, a great number of transit LSPs may be established, which wastes resources. A policy for triggering the establishment of transit LSPs can be configured to enable LDP to use routes meeting the filtering requirements to establish transit LSPs and disable the local LSR from sending Label Mapping message carrying route information not meeting the filtering requirements to the upstream peer. This can effectively reduce the number of LSPs and use network resources more efficiently.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run mpls ldp

    The MPLS-LDP view is displayed.

  3. (Optional) Run ipv4-family

    The MPLS LDP IPv4 view is displayed.

  4. Run propagate mapping for ip-prefix ip-prefix-name

    A policy for triggering the establishment of transit LSPs is configured.

    The propagate mapping command takes effect in either the MPLS-LDP view or MPLS LDP IPv4 view. If the command is configured in both views, only the configuration in the MPLS LDP IPv4 view takes effect.

  5. Run commit

    The configurations are committed.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055103

Views: 20180

Downloads: 35

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next