No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S V800R010C10SPC500 Configuration Guide - MPLS 01

This is NE20E-S V800R010C10SPC500 Configuration Guide - MPLS
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Egress of the Static CR-LSP

Configuring the Egress of the Static CR-LSP

This section describes how to configure the egress of a static CR-LSP. Before you set up a static CR-LSP, specify the egress of the CR-LSP.

Context

Perform the following steps on the egress of the static CR-LSP:

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run static-cr-lsp egress lsp-name incoming-interface interface-type interface-number in-label in-label [ lsrid ingress-lsr-id tunnel-id tunnel-id ]

    The LSR is configured as the egress of the specified static CR-LSP.

    To modify the incoming-interface interface-type interface-number or in-label in-label-value, run the static-cr-lsp egress command to set a new value. There is no need to run the undo static-cr-lsp egress command before changing a configured value.

  3. Run commit

    The configurations are committed.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055103

Views: 22078

Downloads: 37

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next