No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S V800R010C10SPC500 Configuration Guide - MPLS 01

This is NE20E-S V800R010C10SPC500 Configuration Guide - MPLS
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Checking Network Connectivity and Reachability

Checking Network Connectivity and Reachability

Run the ping and tracert commands to check the connectivity and reachability of seamless MPLS networks.

Context

Run the following commands in any view of a BGP LSP endpoint node to check the connectivity and reachability of a BGP LSP.

Procedure

  • Run the ping lsp [ -a source-ip | -c count | -exp exp-value | -h ttl-value | -m interval | -r reply-mode | -s packet-size | -t time-out | -v ] * bgp destination-iphost mask-length [ ip-address ] command to check BGP LSP connectivity.
Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055103

Views: 19440

Downloads: 35

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next