No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S V800R010C10SPC500 Configuration Guide - MPLS 01

This is NE20E-S V800R010C10SPC500 Configuration Guide - MPLS
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Uniform/Pipe Mode for the MPLS Penultimate Hop

Configuring the Uniform/Pipe Mode for the MPLS Penultimate Hop

This section describes the process of configuring the Uniform/Pipe mode for the MPLS penultimate hop.

Pre-configuration Tasks

Before configuring the Uniform/Pipe model for the MPLS penultimate node, complete the following tasks:

  • Configuring physical parameters and link attributes of related interfaces to ensure normal operation of the interfaces

  • Configuring a Uniform/Pipe mode for the MPLS TE penultimate hop, which needs the configuration of an MPLS TE tunnel. see "MPLS TE Configuration" in the HUAWEI NE20E-S Universal Service Router Configuration Guide - MPLS.

NOTE:

Do as follows on MPLS LSP or MPLS TE penultimate hop:

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run mpls

    The MPLS view is displayed.

  3. Run mpls lsp exp-mode { pipe | uniform }

    The global MPLS Diff-Serv mode is set.

    NOTE:
    • The configured mode by running this command take effect only on new LSPs. The reset mpls ldp command can be used to re-establish the original LSPs. Then, the configured mode can take effect on the re-established LSPs.
    • The command is run only on the penultimate hop to control the copy of the EXP value of an outer label to the EXP value of an inner label.

  4. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055103

Views: 19632

Downloads: 35

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next