No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S V800R010C10SPC500 Configuration Guide - MPLS 01

This is NE20E-S V800R010C10SPC500 Configuration Guide - MPLS
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring LDP Extension for Inter-Area LSP

Configuring LDP Extension for Inter-Area LSP

Before configuring LDP extension for inter-area LSP, familiarize yourself with the usage scenario, complete the pre-configuration tasks, and obtain the data required for the configuration.

Usage Scenario

On a large-scale network, multiple IGP areas usually need to be configured for flexible network deployment and fast route convergence. When advertising routes between IGP areas, to prevent a large number of routes from consuming too many resources, an area border router (ABR) needs to aggregate the routes in the area and then advertise the aggregated routes to the neighboring IGP areas. However, by default, when establishing LSPs, LDP searches the routing table for the route that exactly matches the forwarding equivalence class (FEC) carried in the received Label Mapping message. For aggregated routes, only liberal LDP LSPs, not inter-area LDP LSPs, can be set up.

In this case, you can run the longest-match command to configure LDP to search for routes based on the longest match rule to establish inter-area LDP LSPs.

Pre-configuration Tasks

Before configuring LDP extension for inter-area LSP, complete the following tasks:

  • Assign IP addresses to interfaces to make neighboring nodes on the network layer reachable.

  • Configure an IGP to advertise the network segments connecting to interfaces on each node and to advertise the routes of hosts with LSR IDs.

  • Configure the policy for aggregating routes.

  • Configure MPLS and MPLS LDP.

Configuration Procedures

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055103

Views: 20039

Downloads: 35

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next