No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S V800R010C10SPC500 Configuration Guide - MPLS 01

This is NE20E-S V800R010C10SPC500 Configuration Guide - MPLS
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling mLDP P2MP FRR Link Protection

Enabling mLDP P2MP FRR Link Protection

The mLDP P2MP FRR link protection can be configured in the MPLS-LDP view.

Context

mLDP P2MP FRR link protection configured in the MPLS-LDP view enables a device to rapidly detect link faults and converge, which minimizes traffic loss.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run mpls ldp

    The MPLS-LDP view is displayed.

  3. Run mldp p2mp

    mLDP P2MP is enabled globally.

  4. Run mldp p2mp frr link-protection

    mLDP P2MP FRR link protection is enabled.

    NOTE:

    When mLDP FRR link protection is enabled and a link fault is being rectified, a delayed switchback is required. During the delayed switchback, the backup path remains unchanged. When the link recovers, IGP route convergence is fast, causing mLDP to recalculate a new backup path. During path calculation, the old backup path is deleted. To prevent packet loss stemming from the deletion of the old backup path, set the time used to keep advertising the maximum IGP cost to be longer than the mLDP FRR delay. To prevent this problem, run the mpls p2mp frr-wtr command to set an mLDP FRR delay.

  5. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055103

Views: 19648

Downloads: 35

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next