No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


NE20E-S V800R010C10SPC500 Configuration Guide - MPLS 01

This is NE20E-S V800R010C10SPC500 Configuration Guide - MPLS
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring CBTS

(Optional) Configuring CBTS

Service class can be set for packets that MPLS TE tunnels allow to pass through.


When services are iterated to multiple TE tunnels, the mpls te service-class command is run on the TE tunnel interface to set a service class so that a TE tunnel transmits services of a specified service class.


  1. Run system-view

    The system view is displayed.

  2. Run interface tunnel tunnel-number

    The MPLS TE tunnel interface view is displayed.

  3. Run mpls te service-class { service-class & <1-8> | default }

    A service class is set for packets that an MPLS TE tunnel allows to pass through.

    • This command is used only on the ingress of an MPLS TE tunnel.

    • If the mpls te service-class command is run repeatedly on a tunnel interface, the latest configuration overrides the previous one.

  4. Run commit

    The configuration is committed.

Updated: 2019-01-03

Document ID: EDOC1100055103

Views: 19646

Downloads: 35

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next