No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S V800R010C10SPC500 Configuration Guide - MPLS 01

This is NE20E-S V800R010C10SPC500 Configuration Guide - MPLS
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Globally Enabling MPLS and LDP on an Interface

Globally Enabling MPLS and LDP on an Interface

Before you configure a local LDP session, globally enabling MPLS and LDP on an interface.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The view of the interface on which an LDP session is to be established is displayed.

  3. Run mpls

    MPLS is enabled on an interface.

  4. Run mpls ldp

    MPLS LDP is enabled on an interface.

    NOTE:

    Disabling MPLS LDP from an interface leads to interruptions of all LDP sessions on the interface and deletions of all LSPs established over these LDP sessions.

  5. Run commit

    The configurations are committed.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055103

Views: 19996

Downloads: 35

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next