No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S V800R010C10SPC500 Configuration Guide - MPLS 01

This is NE20E-S V800R010C10SPC500 Configuration Guide - MPLS
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring LMP and an LMP Neighbor

Configuring LMP and an LMP Neighbor

LMP and an LMP neighbor are configured on an edge node on a transport network and an IP network to manage the data and control channels and detect link connectivity.

Context

GMPLS uses LMP to manage links of the control and data channels. LMP is classified into the following types:

  • Static LMP: LMP neighbors, control channels, and data channels are manually configured, without exchanging LMP packets.
  • Dynamic LMP: LMP neighbors, control channels, and data channels are all automatically discovered, which minimizes configurations and speeds up network deployment.

Currently, the NE20E supports only static LMP. Perform the following steps to configure LMP and a neighbor on an edge node:

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run lmp

    The global LMP view is displayed.

  3. Run peer name

    An LMP neighbor is created.

    NOTE:
    The neighbor of an IP network edge node is a transport network edge node that directly connects to the IP network edge node. This means that LMP neighbor relationships are created between the ingress EN and ingress CN, and between the egress EN and egress CN.

  4. Run lmp static

    The working mode of an LMP neighbor is set to static LMP.

  5. Run node-id ip-address

    An IP address is assigned to the LMP neighbor.

    The ingress EN's LMP neighbor is the ingress CN on an optical network, and the egress EN's LMP neighbor is the egress CN on the optical network. The ip-address parameter is set to the node ID of the ingress CN or egress CN.

  6. Run te-link te-link-id

    A data-link is created between LMP neighbors.

    A TE-link is a bundle of data-links that directly connected LMP neighbors.

  7. Run link-id local ip ip-address

    A local TE-link ID is set.

  8. Run link-id remote ip ip-address

    A remote TE-link ID is set.

  9. Run data-link interface interface-type interface-number local interface-id ip-address remote interface-id ip-address

    A data-link is bound to a TE-link.

  10. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055103

Views: 19997

Downloads: 35

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next