No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S V800R010C10SPC500 Configuration Guide - MPLS 01

This is NE20E-S V800R010C10SPC500 Configuration Guide - MPLS
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Intra-AS Seamless MPLS

Configuring Intra-AS Seamless MPLS

In the intra-seamless MPLS networking, the access, aggregation, and core layers are within a single AS. A BGP LSP is established across the three layers within the AS to implement E2E service connectivity.

Usage Scenario

As shown in Figure 5-1, the access, aggregation, and core layers belong to the same AS. Intra-AS seamless MPLS can be configured to transmit services between NodeBs (Ethernet stations) and a mobility management entity (MME) or serving gateway (SGW). Intra-AS seamless MPLS applies to mobile bearer networks.

Figure 5-1 Intra-AS seamless MPLS networking

NOTE:
When intra-AS seamless MPLS is configured for an L3VPN, BGP LSPs can be iterated to load-balancing LDP, TE, or LDP over TE tunnels and support ECMP.

Pre-configuration Tasks

Before configuring intra-AS seamless MPLS, complete the following tasks:

  • Configure IGP protocols to implement connectivity at the access, aggregation, and core layers and enable MPLS LDP or MPLS TE to implement MPLS forwarding on a public network.

  • Configure IBGP peer relationships between each Cell Site Gateway (CSG) and Aggregation (AGG), between each AGG and Core ABR, and between each Core ABR and Mobile Aggregate Service Gateway (MASG).

NOTE:

If MPLS TE tunnels are used across the three layers, a tunnel policy or tunnel selector must be configured. For configuration details, see VPN Tunnel Management Configuration.

Configuration Procedures

Figure 5-2 Flowchart for configuring intra-AS Seamless MPLS
Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055103

Views: 19933

Downloads: 35

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next