No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S V800R010C10SPC500 Configuration Guide - MPLS 01

This is NE20E-S V800R010C10SPC500 Configuration Guide - MPLS
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an RSVP-TE Tunnel

Configuring an RSVP-TE Tunnel

MPLS TE reserves resources for RSVP-TE tunnels. These tunnels are established along specified paths, not passing through congested nodes, balancing traffic on a network.

Usage Scenario

The dynamic RSVP-TE signaling protocol adjusts a path of a TE tunnel to adapt to network topology changes. To help implement advanced functions, such as TE FRR or CR-LSP backup, use the RSVP-TE signaling protocol to set up an MPLS TE tunnel.

Pre-configuration Tasks

Before configuring an RSVP-TE tunnel, complete the following tasks:

  • Configure OSPF or IS-IS to implement connectivity between label switching routers (LSRs).

  • Set the LSR ID for every LSR.

  • Enable MPLS in the system and interface views on every LSR.

Configuration Procedures

Figure 3-2 RSVP-TE tunnel configuration
Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055103

Views: 20037

Downloads: 35

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next