No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S V800R010C10SPC500 Configuration Guide - MPLS 01

This is NE20E-S V800R010C10SPC500 Configuration Guide - MPLS
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring the LDP MTU Signaling Protocol

(Optional) Configuring the LDP MTU Signaling Protocol

LDP MTU signaling can be configured to allow Label Mapping message carrying MTU TLVs to be sent.

Context

An MTU value determines the maximum number of bytes that can be transmitted by a transmit node at one time. If a packet exceeds the MTU supported by the receive node or a transit node, the packet is fragmented or discarded, which imposes heavy burden on network transmission. After the LDP MTU signaling protocol is configured, packets smoothly pass through every transit device and reach receive ends without packet reassembly.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run mpls ldp

    The MPLS-LDP view is displayed.

  3. Run mtu-signalling [apply-tlv]

    The node is enabled to send Label Mapping message carrying MTU TLVs.

  4. Run commit

    The configurations are committed.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055103

Views: 20174

Downloads: 35

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next