No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S V800R010C10SPC500 Configuration Guide - MPLS 01

This is NE20E-S V800R010C10SPC500 Configuration Guide - MPLS
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling P2MP TE Auto FRR

Enabling P2MP TE Auto FRR

Enabling P2MP TE Auto FRR on the ingress or a transit node of the primary tunnel is the prerequisite of configuring TE Auto FRR.

Context

Perform either of the following operations to enable P2MP TE Auto FRR on the NE20E:
  • Configure the entire device and its interface when Auto FRR needs to be configured on most interfaces.
  • Only configure a specified interface when Auto FRR needs to be configured only on a few interfaces.

Procedure

  • Configure the entire device and its interface.
    1. Run system-view

      The system view is displayed.

    2. Run mpls

      The MPLS view is displayed.

    3. Run mpls te auto-frr self-adapting

      MPLS TE Auto FRR is enabled globally.

      P2MP TE FRR only supports link protection, while a bypass tunnel that the ingress establishes supports node protection by default. As a result, the bypass tunnel fails to be established. To prevent the establishment failure, configure the self-adapting parameter in the mpls te auto-frr command, which enables the ingress to automatically switch from node protection to link protection.

    4. Run mpls te p2mp-te auto-frr enable

      P2MP TE Auto FRR is enabled globally.

    5. Run quit

      The system view is displayed.

    6. Run interface interface-type interface-number

      The view of the outbound interface on the primary tunnel is displayed.

    7. (Optional) Run mpls te auto-frr { block | default }

      TE Auto FRR is enabled.

      After Auto FRR is enabled globally, the mpls te auto-frr default command is by default run on all MPLS TE interfaces on the device. To disable Auto FRR on a specified interface, run the mpls te auto-frr block command on that interface. After the mpls te auto-frr block command is run, Auto FRR is disabled on the specified interface, regardless of whether Auto FRR is enabled or reenabled globally.

      NOTE:
      • If the mpls te auto-frr default command is run, the interface Auto FRR capability status is the same as the global Auto FRR capability status.

    8. Run commit

      The configuration is committed.

  • Configure a specified interface.
    1. Run system-view

      The system view is displayed.

    2. Run mpls

      The MPLS view is displayed.

    3. Run mpls te p2mp-te auto-frr enable

      P2MP TE Auto FRR is enabled globally.

    4. Run quit

      The system view is displayed.

    5. Run interface interface-type interface-number

      The view of the outbound interface on the primary tunnel is displayed.

    6. Run mpls te auto-frr { default | link | self-adapting }

      P2MP TE Auto FRR is enabled.

    7. Run commit

      The configuration is committed.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055103

Views: 19543

Downloads: 35

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next