No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


NE20E-S V800R010C10SPC500 Configuration Guide - MPLS 01

This is NE20E-S V800R010C10SPC500 Configuration Guide - MPLS
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Remote LDP Session

Configuring a Remote LDP Session

A remote MPLS LDP session can only be established after LSR IDs are configured and MPLS LDP is enabled on both ends of the MPLS LDP session.

Usage Scenario

Remote LDP sessions are used in LDP over TE and L2VPN scenarios:
  • LDP over TE: If the core area on an MPLS network supports TE and the edge devices run LDP, two LSRs on the edge establish a remote LDP session. LDP over TE allows a TE tunnel to function as a hop on an LDP LSP.
  • L2VPN: Devices exchange protocol packets over an LDP session. If the devices are indirectly connected, a remote LDP session must be configured. However, no remote LDP session needs to be configured for a static PW.

Pre-configuration Tasks

Before configuring a remote LDP session, configure static routes or an IGP to ensure that IP routes between LSRs are reachable.

Configuration Procedures

Figure 4-3 Remote LDP session configuration
Updated: 2019-01-03

Document ID: EDOC1100055103

Views: 19371

Downloads: 35

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next