No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE20E-S V800R010C10SPC500 Configuration Guide - MPLS 01

This is NE20E-S V800R010C10SPC500 Configuration Guide - MPLS
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Dynamic BFD for CR-LSP

Configuring Dynamic BFD for CR-LSP

Static BFD for CR-LSP can be configured to monitor an RSVP CR-LSP and protect traffic along a CR-LSP.

Usage Scenario

Compared with static BFD, dynamically creating BFD sessions simplifies configurations and reduces configuration errors.

Currently, dynamic BFD for CR-LSP cannot detect faults in the entire TE tunnel.

NOTE:

BFD for LSP can function properly though the forward path is an LSP and the reverse path is an IP link. The forward and reverse paths must be established over the same link. If a fault occurs, BFD cannot identify the faulty path. Before deploying BFD, ensure that the forward and reverse paths are over the same link so that BFD can correctly identify the faulty path.

Pre-configuration Tasks

Before configuring dynamic BFD for CR-LSP, configure an RSVP-TE tunnel.

Translation
Download
Updated: 2019-01-03

Document ID: EDOC1100055103

Views: 20103

Downloads: 35

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next